Flat TireDealing with a flat tire can be a troublesome event if you are not prepared. When your car’s tire goes flat, this kind of situation should not be a problem for you as long as you are properly prepared. After all, most cars already come with spare tires and a jack, along with other odds and ends that would help you facilitate changing your tires in no time at all. If you are uncomfortable with changing a tire or calling a friend, calling CAA in Canada or AAA in the US as long as you are a member will lessen the task for you.

Dealing with a Flat Tire Yourself

For some it might even be appropriate to try changing their tire when it is still inflated and under perfect conditions as a test run, so that you know how to change the tires. A neighbor had to call his oldest son to come and help him one night at 2 in the morning, because he could not figure out how to change the tire on his car.

There are proper ways to change a tire. Always make sure that you are doing so with safety in mind. To change a tire or a couple of tires, park your car first in an area where the ground is level. This helps to lessen the chance of the car rolling forward or backwards off the jack. Always place  parking brake on before you do any work at all. If your car is equipped with a manual transmission system, place it in gear. Always turn off your engine for there is no need for it to be turned on and running.

However, if you have no choice and have to park in an area where there is an incline, put a huge rock or a wheel chock beneath the opposing wheel. So that you would not find your car rolling down the incline.

In fact whether you are on an incline or not, it is always a good idea to block the wheels. You will stop the vehicle from moving for any reason. Also make sure you are well away from traffic so you can change the tire safely.

Changing Your Flat Tire

Remove  your spare tire as well as a tire iron and the jack from the trunk. Remove the hub cap if there is one. Then, loosen the lug nuts on your wheel while the wheel is still touching the ground. Do this before you jack up your car. Make sure that you loosen each and every lug nut that connects your tire to the wheel without unscrewing them completely. As long as the lug nuts are loosened up and not unscrewed completely, there is no chance that the wheel can come off by accident.

Following the instructions in your cars manual, place the jack in the proper location and  start jacking up your vehicle. Although we are repeating this point again, it is one of the most important things you should do. Check your car owner’s manual for the specifics on the location as per where you should put your jack.

When you jack your car, make sure that you raise your car a little higher than needed so that you can not only remove the old flat tire but you can also install the new inflated tire.

Once the car has been jacked up,  unscrew completely all of the lug nuts. Remove the flat tire and place it to the side. Roll your new tire into position and mount it on the lug bolts. Then, place back the lug nuts and tighten them up as tightly as possible without turning the wheel.

Now lower the jack until the wheel is contact with the ground. But not bearing the full weight of the car. Tighten the lug nuts one more time and then lower the jack completely and remove it. If you have a hub cap, you can now put it back on.

Repair Your Tires Immediately

We suggest that you have your spare tire repaired as soon as possible. Since you never know when you might have another flat tire. Also check the inflation on the spare tire as soon as possible since most tires will lose a little bit of air over time.

We are glad to receive comments from our readers and suggestions about dealing with flat tires. For more safe driving ideas, click here.